Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: TO AVOID
SERIOUS
iNJURY,
BEFORE
PERFORMING
ANY SER-
ViCE OR ADJUSTMENTS:
1.
Depress
brake
pedal fully and set parking
brake.
2.
Place
attachment
clutch
in "DISENGAGED"
position.
3.
Turn ignition key to "STOP"
and remove
key.
4.
Make sure the blades
and all moving
parts have completely
stopped.
5.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come in contact
with plug.
TRACTOR
TO REMOVE MOWER
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Lower attachment
lift lever to its lowest
position.
3. Roll belt off engine pulley (M).
4. Remove retainer spring (K), slide collar
(L) off and push housing guide (P) out
of bracket.
5. Remove clutch cable spring (Q) from
idler arm (R).
6. Disconnect
front link (E) from mower
- remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C)
from rear mower bracket (D) - remove
retainer springs and washers.
8. Go to other side of mower and discon-
nect the suspension
arm and rear lift
link.
_,
CAUTION:
After rear lift links are dis-
connected,
the attachment
lift lever will be
spring loaded. Have a tight grip on lift lever
when changing position of the lever.
9. Slide mower out from under right side
of tractor.
%
IMPORTANT:
If an attachment
other than
the mower is to be mounted on the tractor,
remove the front link (E) and rear lift liks
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO iNSTALL MOWER
Be sure tractor
is on level surface
and
engage
parking
brake,
1.
Lower
attachment
lift lever to it's lowest
position.
_, CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower
it
slowly
and engage
in lowest position.
NOTE:
Be sure mower
side suspension
arms (A) are pointing
forward
before
slid-
ing mower
under tractor.
2.
Slide mower
under
tractor
until it is
centered
under tractor.
3.
ATTACH
MOWER
SIDE SUSPENSION
ARMS
(A) TO CHASSIS
- Position
hole
in arm over
pin (B) on outside
of tractor
chassis
and secure
with washer
and
retainer
spring,
4.
Repeat
on opposite
side of tractor.
21
Publicidad
