Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
WARNING:
Do not short battery ter-
minals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting
battery, re-
move metal bracelets, wristwatch
bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position and
open battery box door.
2. Disconnect
BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
5. Connect BLACK grounding
cable
to negative (-) terminal with remain-
ing hex bolt and keps nut. Tighten
securely.
6. Close battery box door.
Seat
TO
1.
2.
REPLACE
HEADLIGHT
BULB
Raise hood.
Remove bulb holder from the hole in
the backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS
AND RELAYS
Loose
or damaged
wiring
may cause
your tractor
to run poorly,
stop running,
or
prevent
it from starting.
• Check
wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor.
Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Battery
Box Door
Headlight Wire
Connector
Keps
Nut
Hex
olt
Positive
(Red)
Cable
Negative (Black)
Cable
26
Publicidad
