FUXTEC RM51SA96 Instrucciones De Uso Originales página 41

the dipstick.
- Change the oil every 50 working hours or after months. You will likely need to
change the oil more often in dusty and dirty conditions.
Filling up with GASOLINE
Fill the fuel tank to the bottom of the filler neck. Do not overfill the tank. Use fresh,
clean unleaded fuel. Never mix oil with gasoline. Purchase power in quantities that
can be used within 30 days to guarantee the freshness of the power.
Prolonged storage of the lawnmower will change the gasoline's chemical
composition, which can cause starting difficulties and unsteady running of the
engine.
ATTENTION:
Remove any oil or gasoline residue. Do not store, spill, or use
gasoline near naked flames.
ATTENTION:
Fuels mixed with alcohol (called gasohol) or the use of ethanol or
methane can attract moisture, causing separation and formation of acid during
storage. Acidic gases can damage the engine's fuel system while the device is in
storage. Drain the tank system if the device is stored for more than 30 days to
avoid damage to the motor. Empty the fuel tank, start the engine and let it run
until the fuel line and carburetor are empty. Use fresh gasoline the next time you
use the device. Never use engine or carburetor cleaning agents inside the fuel tank.
This can lead to permanent damage.
Before refueling, ensure that the engine is switched off and the cutting blade has
stopped entirely. This is done by releasing both the drive and the brake lever on
the handlebar. Please wait at least 5sec until the motor has stopped entirely. Only
then, open the tank cap slowly and start filling carefully.
41
Original User Manual FUXTEC FX-RM51SA96_rev03