FUXTEC RM51SA96 Instrucciones De Uso Originales página 43

22. Starting/stopping the engine
Start
Make sure that the engine is filled with sufficient oil and gasoline before you start it.
Pull the brake lever (upper lever) against the handle and pull the starter cable
slightly until resistance is felt. Then pull the starter cable smoothly until the engine
starts.
NOTE:
Do not operate the wheel drive lever at the same time. When the engine has
started, and you want to use the self-propulsion, do you run the lower lever.
Due to a protective layer on the engine, a slight smoke may be produced when you
use the device for the first time. This is a standard procedure. Pull the brake lever
towards the push handle. Do not let the pull starter snapback.
Stopping
Release the brake lever to stop the motor.
WARNING:
The blade will continue to rotate for a few seconds after the engine
is turned off. Unplug the spark plug connector when leaving the mower unattended.
Stopping
Release the brake lever to stop the engine.
WARNING:
The blade will continue to rotate for a few seconds after the engine
is turned off. Turn the spark plug off when leaving the mower unattended.
MOWING INSTRUCTIONS
- In certain circumstances, such as high grass, it may be necessary to raise the
cutting height to reduce the thrust and engine load, leading to grass residue. It
may also be required to reduce the essential speed and push the mower twice over
this area
- Reduce the cutting width by covering the previous cut again to perform heavy
cutting work
- Keep the upper part of the engine around the starter free of grass and chopped
grass clippings. This improves the engine airflow and prolongs the engine life
43
Original User Manual FUXTEC FX-RM51SA96_rev03