E
HOW TO SET UP YOUR TRACTOR
Positive termina!
must be ¢enne_
first to prevent sparking
from aceideno
tal grounding.
o
Lift hood to raised position.
o
Open terminal access doors, remove terminal protec-
tive caps and discard.
o
if this batte_ is put into service after month and year
indicated on label (labet located between terminals)
charge battery for minimum of one hour at 6-!0 ampso
First connect RED battery came to positive (+) batten]
termina[ with hex bolt, flat washer, lock washer and hex
nut as shown_ Tighten secumty.
o
Connect BLACK grounding cable to negative (-) bat-
teD, terminal with remaining hex bolt, fiat washer, lock
washer and hex nut. Tighten securely.
o
C_ose terminal access doors.
Use terminal access doors for:
o
inspection for secure connections
(to tighten hard°
ware).
o
Inspection for corrosion°
o
Testing batten].
o
Jumping (if required).
o
Periodic charging.
LOCK
FLAT
HEX NUT
WASHER
WASHER
_SCARDTEBMiNAL
/
HEX
PROTECTIVE
CAPS
BOLT
POSITIVE
(BEO)
CABLE
NEGATIVE
(BLACK)
CABLE
RG. 2
iNSTALL
SEAT (See Figo 3}
Adjust _at
before tightening adjustment knob°
Remove cardboard packing on seat pan
o
P_ace _at
on seat pan and assemble shoulder boil
Tighten shoulder bolt securely.
o
A_emb_e
adiustment knob and flat washer toosetyo
Do not tighten.
o
Lower seat into operating position and sit on seat.
o
Slide seat untit a comfor_abJe position is reached which
atiows you to press clutch/brake
pedal aH the way
down.
o
Get off seat without moving its adjusted position.
o
Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDEN
BOLT
ADJUSTMENT
KNOB
FIG. 3
"FLAT WASHER
CHECK TiRE PRESSURE
The tires on your tractor were ovednflated at the factoR] for
shipping purposes.
Correct tire pressure is important for
best cutting performance.
*
Reduce tire pressure to PSi shown in "PRODUCT
SPECIFICATIONS"
on page 3 of this manual.
CHECK BRAKE
SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted.
See "TO ADJUST
BRAKE" in the Service and Adjustments
section of this
manual.
8