American Standard Townsend 2691004 Manual Del Propietário página 5

6
INSTALLING THE 1-1/2" (38MM) DIAMETER TAIL PIECE ASSEMBLY INTO P-TRAP
8" (203mm) tail piece included with Drain Kit 1582.000.YYY.
A slip-joint nut and a flanged, 1-1/2" (38mm)
diameter tail piece are recommended. (See Fig. 3)
Slide the slip-joint nut over tail piece towards
the flanged end as shown.
Slide the P-trap slip-joint nut and seal over
the tail piece as shown.
Insert the tail piece into the P-trap.
The flange of the tail piece should be approximately
2" (51mm) above the finished floor when fully inserted
to the P-trap.
The tail piece can be cut if necessary.
7
Carefully set the tub into position using the outline on the floor as a guide. Connect the tailpiece to the
tub drain. Tighten all of the drain connections.
8
Fill the tub with water and draitn. Check for leaks and re-tighten connections as necessary.
9
Apply a bead of Tub & Tile caulk around the bottom edge of the tub where it meets the floor.
Remove any excess caulking.
TAIL PIECE
ASSEMBLY
2"
(51mm)
FINISHED
FLOOR
P-TRAP
SLIP-JOINT
NUT & SEAL
(PROVIDED BY
INSTALLER)
FIG. 3
THREADED PORTION
OF DRAIN BODY
SLIP-JOINT NUT
TAIL PIECE
P-TRAP
(PROVIDED BY
INSTALLER)