YATO YT-82751 Manual Original página 10

TOOL CHARACTERISTICS
The orbital sander is a power tool designed mainly for fi nishing works when machining wood and to a lesser extent for sanding
metal surfaces, especially in the corner and hard to reach places. Thanks to the battery power supply, the sander ensures high
mobility. The sanding is carried out using commercially available sanding sheets: sandpaper or sand cloth in the form of appro-
priately shaped surfaces. Under no circumstances should the tool be used for machining materials other than those mentioned
above, e.g. for sanding gypsum skim coats, fi bre-reinforced putty, etc. The correct, reliable and safe operation of the sander
depends on its proper use, therefore:
Read this entire instructions manual before the fi rst use of the tool and keep it for future reference.
Caution! Dust generated during the sanding of certain surfaces can be harmful to health and even toxic.
The above remark applies, among others, to the sanding of surfaces covered with paints containing lead, certain types of wood,
certain metals (e.g. lead) and materials, therefore, eff ective dust extraction, dust masks and other skin and respiratory protection
measures should be used during work. The supplier shall not be liable for any damage resulting from failure to comply with the
safety instructions and recommendations specifi ed in this instructions manual.
EQUIPMENT
The sander is supplied complete. The power supply battery and battery charging station are not included.
TECHNICAL PARAMETERS
Parameter
Type
Rated voltage
Orbital stroke rate
Plate dimensions
Sanding sheet dimensions
Weight
Noise level
- sound pressure L ± K
pA pA
- sound power L ± K
wA wA
Vibration a ± K
h
Protection rating
Battery type
The declared total vibration emission value and declared noise emission value have been measured using the standard test
method and can be used to compare one tool to another. The declared total vibration emission value and declared noise emission
value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual con-
ditions of use (including all parts of the work cycle, such as the time when the tool is turned off or idle and the activation time),
must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
10
O R I G I N A L
EN
Unit
[VDC]
[min ]
-1
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82751
18
13,000
90 x 187
90 x 187 / 90 x 238
1.48
77.8 ± 3.0
88.8 ± 3.0
5.45 ± 1.5
IPX0
Li-Ion