Publicidad
Idiomas disponibles
Idiomas disponibles
Janome 644D Instruction Manual
1
3
www.toews.com
34
4
3
2
1
2
A
4
Threading the Machine
The left illustration shows the completed threading
conditions of the four threads.
Lower looper thread
Upper looper thread
Right needle thread
Left needle thread
Thread guide
Thread guide plate
Threading chart
The machine is pre-threaded to make threading
easier.
Tie the end of a new thread to one of the pre-set
threads, and pull it to draw the new thread through
the machine, following the steps below.
* Turn off the power switch before threading the
machine.
1. Pull the threads from the spools and draw them
through the thread guides, then tie the thread
ends together.
2. Raise the presser foot, draw the threads until the
knots are coming out from under the back of the
presser foot.
3. However, stop drawing the needle threads when
the knots reach just before the needle eye.
Cut the knots and thread the needle eye.
4. Before starting sewing, clear the needle threads
from under the presser foot to make sure they are
not caught below the needle plate.
(Draw the needle threads in the direction A.)
Then pull out the threads to the back
approximately 10 cm (4˝) away from the presser
foot. Lower the presser foot, and you are now
ready to sew.
Thread guide
Needle
Needle thread
Presser foot
Needle plate
• For re-threading the machine easily, start from the
lower looper, upper looper, right needle and left
needle threads.
Make sure to clear the needle threads out from
below the needle plate and draw them to the
back and under the presser foot about 10 cm (4˝).
644D Owners Manual/ User Guide
Janome Serger
Publicidad
