Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
Continued
PROBLEM
POSSIBLE CAUSE
Hand Sensor
a. Indicates battery power is low in
Module flashes
quickly 5 times
Toilet leaks
a. Poor supply line connection
b. Poor bowl to tank/floor connection
Toilet bowl rocks
a. Wax ring not fully compressed
after installation
b. Floor not level
The Hand Sensor
a. The Flush Control Module in tank is
Module can light
up by sensing,
b. The codes of the Hand Sensor
but does not
flush
c. The battery pack in the Flush
CARE AND CLEANING
When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry
with a soft cloth. WARNING: Do not use in-tank cleaners. These products can seriously corrode
ttings in the tank. This damage can cause leakage and property damage. American Standard
shall not be responsible or liable for any damage caused by the use of in-tank cleaners.
Control module FCC ID: 2AW23-D7020-01
Sensor module FCC ID: 2AW23-D7020-02
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This devise may not cause harmful Interference, and
(2) This devise must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
7302484-100 Rev. E (6/23)
Hand Sensor Module
not connected properly.
Module and Flush Control Module
are not matched or synchronized to
each other.
Control Module may not be
orientated correctly.
CORRECTIVE ACTION
a. Replace batteries in Hand Sensor Module.
a. Remove supply line, inspect and reconnect. Replace supply line if
leak continues.
b. Review Step 2 through 8 of installation procedure.
a. Retighten bowl-to-floor knobs.
b. Use toilet shims and/or place a bead of caulk around the base of
the toilet.
a. Ensure wire from Flush Control Module to Flush Valve Body
is fully connected.
b. Install Hand Sensor Module batteries within 3 minutes after
installing Flush Control Module batteries to allow codes to match
or syncronize.
c. Orientate the batteries in the battery pack
Publicidad
