LEITZ iLAM TOUCH 2 A3 Instrucciones De Uso página 5

For your safety
WARNING!
Read all safety warnings and all
instructions.
• Please take the time and read the general safety
instructions. You can find the general safety
instructions in a separate booklet. This booklet is
included.
• If the product is not installed and used in accordance
with this manual, it may cause harmful interference
with radio or television reception or affect other
electronic devices in residential areas. Non-
compliance invalidates the permission to operate
this product.
• Ensure good aeration while laminating (e. g. open a
window).
• Do not place anything on top of the device and do
not insert anything into the venting slots.
• Unplug and let the device cool down before cleaning,
moving or storing it. When carrying the laminator,
always hold it by the recessed grips on both sides.
To ensure the best possible lamination and to avoid
any damage to the laminator, please take the following
precautions:
• Laminating pouches are made of two sides linked
to each other.Never laminate with only one side of a
laminating pouch.
• Always insert laminating pouches into the unit with
the folded side first. Do not insert a laminating pouch
until the previous laminated document has been
removed.
• Always insert the pouch in the centre of the laminator
entry area.
• Never laminate empty pouches. Always insert a
document into the pouch when laminating.
• Do not cut the pouch prior to lamination. Trim the
pouch to size after lamination.
• Do not laminate heat-sensitive, wet, wavy or crinkly
materials.
• Do not laminate materials thicker than specified in
this manual.
• Do not laminate metal objects.
• The lamination process is irreversible. Please keep
this in mind when laminating unique pieces.
• Do not pull or push the pouch and do not switch off
the laminator during normal lamination.
Instruction Manual
Use
How to laminate a document 3
1. Set the laminator A up on a stable surface (e.g.
table) close to a mains outlet. Ensure there is
sufficient space behind the laminator so the
laminated document is not blocked and can easily
be removed.
2. Connect the mains cord B with mains socket and
laminator A.
3. Fold out the input D and output E trays.
4. Set the rear switch F in the "I" position to turn on the
laminator. The On/Off button H will light blue and
you will hear a beep.
5. Press the On/Off button H. The On/Off button H will
start flashing blue. The laminator heats up. As soon
as the On/Off button H lights steadily blue again
and you hear beep, the working temperature has
been reached.
6. Insert the document into the laminating pouch. Align
it to the pouch's folded side as close as possible
and ensure even margins on the left and right.
Pouches that are too large can be trimmed to size
after lamination.
Warning! Lamination is permanent. Before laminating
unique pieces, test the process with a similar item.
Always insert smaller objects in the middle of the
input tray so that they are recognized by the thickness
sensor.
7. Insert the pouch with the folded side first straight
into the input tray D until it gets pulled in. The
laminated document is automatically driven out at
the output tray E.
8. Remove the laminated document and leave it on a
flat surface for one minute to cool down.
9. If you do not wish to laminate further documents,
switch off the laminator.
EN
5