Lincoln Electric LFA 3.0 Manual De Instalación Y De Uso página 11

A
Fig. 6.5 Hinge of the wall/unit side
6.3 Lubrication of the rotating hinge
To make sure that the rotating hinge can turn freely, you must
lubricate the axle regularly.
Fig. 6.6
• (B) Apply grease into the grease nipple with a grease gun.
Recommended grease type: standard EP2 bearing grease
Fig. 6.6 Lubrication of the rotating hinge
7 TROUBLESHOOTING
If the product does not function (correctly), consult
the checklist below to see if you can remedy the
error yourself. Should this not be possible, contact
your supplier.
WARNING!
Obey the safety regulations that are written in
chapter 3 when you carry out the activities below.
Symptom Problem
General
Extraction Pollution of
capacity is the facility
insufficient
0507270020/010921/A LFA 3.0 | 4.0 | 3.1 | 4.1
B
B
Possible Solution
cause
Throttle valve is Open the throttle
closed valve
Flexible hose(s) Replace flexible
torn or loose hose(s) or install
correctly
Rubber seal(s) Replace rubber
torn or installed seal(s) or install
incorrectly correctly
Outside air is Make the duct
extracted into system airtight
the connected
duct system
Symptom Problem
Extraction Hood does
hood not in not stay in
balance the desired
position
You cannot
move the
hood in the
desired
position
Entire arm Arm does not
(both arm stay in the
sections) falls desired
down position
LFA 3.0 | LFA 4.0
Extraction Arm does not
arm creaks or move
squeaks smoothly
Movement Friction in the
problem of middle hinge
the hood side
of the arm
LFA 3.1 | LFA 4.1
Extraction Arm does not
arm creaks or move
squeaks smoothly;
excessive
wear of parts
The hood side Arm does not
of the arm stay in the
falls down desired
position
8 SPARE PARTS
The following spare parts are available for the
products;
8.1 LFA 3.0 | LFA 4.0
Refer to exploded view Fig. VI on page 63 and the spare
parts list on page 64
8.2 LFA 3.1 | LFA 4.1
Refer to exploded view Fig. VII on page 65 and the spare
parts list on page 66
9 DISPOSAL
After life of the product, dispose of it in accordance
with federal, state or local regulations.
Possible Solution
cause
Not enough Adjust the friction
friction of the hood hinge;
refer to paragraph
6.2.1
Too much
friction
Spring tension Increase the spring
too low tension of the hinge
at the wall/unit
side; refer to
paragraph 6.2.3
Insufficient Lubricate the hinge
lubrication points; refer to Fig.
IV (C) on page
61
Not enough Adjust the friction
friction due to in the middle
aging hinge; refer to
paragraph 6.2.2
Too much
(LFA 3.0 and LFA
friction
4.0 arms)
Too much
Clean the friction
friction due to mechanism in the
pollution middle hinge
Insufficient Lubricate the hinge
lubrication points; refer to Fig.
V (C) on page 62
Lubricate the steel
cable near the
balance wheel;
refer to Fig. V (B)
on page 62
Spring tension Increase the spring
too low tension; refer to
paragraph 6.2.2
(LFA 3.1 and LFA
4.1 arms)
EN | 10