Publicidad
Idiomas disponibles
Idiomas disponibles
-
Do not use corrosive products to clean the floor
beneath the appliance.
-
Do not use direct or high pressure water jets to clean
the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
-
Clean the surfaces with a cloth or sponge using water
and proprietary non-abrasive detergents. Follow the
direction of the satin finish lines. Rinse repeatedly
and dry thoroughly.
-
Do not use pan scourers or other iron items.
-
Do not use chemical products containing chlorine.
-
Do not use sharp objects which might scratch and
damage the surfaces.
THE COOKING WELLS
-
Clean the wells by bringing the water to the boil, with
the addition of grease remover detergent if
necessary.
-
Remove any limescale deposits with a proprietary
limescale remover.
INSTRUCTIONS FOR
V.
MAINTENANCE
14. REMINDERS FOR THE MAINTENANCE
TECHNICIAN
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR
INJURY RESULTING FROM FAILURE
TO OBSERVING THE FOLLOWING
RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated
room.
Do not obstruct any air vents or drains present on the
appliance.
Do not tamper with appliance components.
Appliance maintenance and conversion to a different
type of gas must be carried out by qualified
technicians authorized by the manufacturer, in
compliance with current safety standards and the
instructions in this manual.
15. CONVERSION TO ANOTHER TYPE OF
GAS
See Chapter " Instructions for installation ".
16. COMMISSIONING
See Chapter " Instructions for installation ".
17. TROUBLESHOOTING
GAS FRYERS
THE PILOT BURNER DOES NOT LIGHT.
Possible causes:
-
Insufficient gas supply pressure.
-
Blocked tubing or nozzle.
-
Defective gas tap or valve.
-
Igniter defective or not properly connected.
-
Igniter or igniter wire defective.
-
Safety thermostat faulty.
PILOT BURNER GOES OUT DURING USE.
Possible causes:
-
Insufficient gas supply pressure.
-
Defective gas tap or valve.
-
Defective thermocouple or insufficient heating.
-
Thermocouple incorrectly connected to gas tap or
valve.
-
The gas cock and/or gas valve knob is not being
pressed enough.
-
Safety thermostat faulty.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
-
Insufficient gas supply pressure.
-
Blocked tubing or nozzle.
-
Defective gas tap or valve.
-
Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED.
Possible causes:
19
Publicidad
