Descargar Imprimir esta página

FITFIU FITNESS MUB3003P Manual Del Usuario página 49

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
GENERAL SET-UP INFORMATION
The assembly should be done by two aduits if possible. Carefully read the manual and look at the explanatory
drawing on previous page before starting setting the item up.
Remove all packaging material and spread all parts onto an even surface to get an overview and facilitate the assembly.
Protect the set-up area ground by using any kind of cover.
Check all parts listed in the parts' list are included. Do not dispose of the packaging material until the assembly
is completed.
Note: When using tools a danger of injury exists. Use caution and keep the work environment as risk-free as
posslble. Dispose of foils or plastic bags that pose a choking hazard to children.
Note: Sorne of the screws are already in the respective holes; please loosen them before performing the appropriate
installation step. Also note the "L" (left) and "R" (right) markings for the correct structure.
Only the supplled tool is requlred to set-up the item.
ASSEMBLY STEPS
NOTE
Don't fully tighten all boits before the entire unit has been completely assembled.
STEP I
A.
Place the two upright components (05 R&L) on a level floor and place the rear cross tube (06) in between the
two upright assemblies. lnsert four half threaded hex head boits (42) along with four washers (37-1) through
the upright assembly (05 R&L) into the rear cross tube (06) as shown. Secure the upright assembly (05 R&L)
and rear cross tube (06) with four washers (37) and tighten with four nylon nuts (49).
B.
Place the backrest holder adjustment tube (07) between the two upright assemblies (05 R&L).
WEIGHT BENCH MUB3003P
49
EN

Publicidad

loading