Kenmore 911.47862 Guía Para El Uso Y Cuidado página 18

OPERATION
OvenControl,Clock, and Timer
Your new control has a series of tones
that wilt sound at different times.
These tones may sound while you set
the control for an oven function, or at
the end of the oven function. It will
also alert you that there may be a
problem with the functions. Below
are the types of tones and a brief
description of each.
TONES WHILE SETTING THE
CONTROL - When you press a touch
P _d, you will hear a beep. This beep
will let you know you have placed
enough pressure on the pad to
activate it.
END OF TIMED CYCLE TONE -
At the end of a timed cooking
function, you will hear 3 short beeps
followed by 1 beep every 6 seconds.
This 6-second beep will continue
to sound until the CLEAR/OFF
pad is pressed, or you may select
the special feature to cancel this
6-second beep from sounding at the
end of future cycles.
TO CANCELTHE _SECOND BEEP:
1. Press and hold the BAKE and
BROIL pads, at the same time, for
3 seconds, until the display shows
"SF"
2. Press the HOUR/MIN KITCHEN
TIMER ON/OFF pad. The
display will show "CON BEEP"
(continuous beep).
3. Press the HOUR/MIN KITCHEN
TIMER ON/OFF pad again. The
display will show "BEEP" (beep
canceled).
4. Press the START pad.
If you would like to return the
6-second beep, repeat steps above
until the display shows your choice
and press the START pad.
A'n'ENTION TONE - This tone will
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a. Setting a clean cycle and the oven
door ks not properly closed.
b. Setting a function and not pressing
the START pad.
c. Pressing an additional function pad
without first setting a temperature
or time.
d=
"ERR" will flash if you set an
invalid temperature. Press the
CLEAR/OFF pad to clear the
control and reset your oven
function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE - When you start a
bake operation, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
If you set an oven function and the
control beeps while the display is
flashing "F" and a number "F-4" or
letter "FI," there may be a problem
with the control or oven. Simply press
the CLEAR/OFF pad and wait about
an hour. Try setting the function
again. If the code repeats, write down
the code and call for service. Tell the
technician what code was flashing.
18