Publicidad
Idiomas disponibles
Idiomas disponibles
A
WARNING:
To prevent accidental
starting
that could cause serious personal
injury, always disconnect
the tool from the power source when assembling
parts, making adjustments,
installing or removing sanding
belt, cleaning,
or
when it is not in use.
TURNING
THE BELT
SANDER
ON/OFF
(Fig. 2)
To turn on the belt sander,
connect
the plug to an electrical
outlet, and press the on/off
trigger switch.
To turn it off, release the
trigger switch.
LED WORKLIGHT
(Fig. 3)
The LED worklight,
located below
the front handle, will turn on
when the on/off trigger switch
is depressed.
This provides
additional
Uighting on the surface
of the workpiece
for operation.
The LED worklight
will turn off
when the switch is released.
TO iNSTALL
SANDING
BELT
(Fig. 4}
1.
Disconnect
the belt sander
from the power source.
2.
Place the sander on its side,
and pull the lock lever out and
towards
the front of the tool.
3.
Insert the new sanding
belt
around both rollers. Make sure
that the arrow on the inside of
the sanding
belt points in the
same direction
as the arrow
indicated
on the sander.
Fig. 2
ON/OFF trigger switch
Lock-on
button
worklight
_
Fig. 4
Arrow
Lock lever
Roller
Base plate
Roller
12
Publicidad
