Publicidad
Idiomas disponibles
Idiomas disponibles
-
Coversto be placedoverthe
holesforthe transportbolts
(afterremoving them).
-
Clampfordrainhose.
-
Wrenchfor levelling.
-
Elbowfor attaching the drain
hose,e.g.to a sink.
Depending onthe type of
connection, t he followingmayalso
berequired:
Y-connector (canbe obtained
fromanyhardware store)in
casethereisonlya coldwater
connectionavailable.
Dimensions
a -- 27.0 inches (686 mm)
b -- 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d -- 16.0 inches (407 mm)
Door opening
angle 180 °
Approx. weight -- 220 Ibs (100 kg)
Installation
area
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets
(set)
from Siemens Customer
Service (WMZ 2200).
Units are not designed to be
stacked.
Units are not designed for
under counter
installation
Pedestal
Mounting
If mounting
the washer on the Sie-
mens pedestal (accessory
no.
WZ 20395, for colored variant, ac-
cessory number WZ20395A)
follow
the instructions
supplied
with the
pedestal.
D
Install pedestal
prior to
removing transport
bolts.
Closet
If installing the washer in a closet,
observe the minimum
distances
according
to the following
table:
Minimum
Installation
Clearances
Any residual moisture
inside the
drum is due to the final testing
which every washing
machine
undergoes
before leaving the
factory.
On the rear of the appliance:
_
.... iili _
ii!i!i_,i
¸
-
Power cord with plug.
C -- cold water connection
H -- hot water connection
Useful tools
The following tools are helpful:
-
Flat head screwdriver.
-
Closed wrench (1/2"/13mm).
-
Bubble level.
Never ground the washer to
plastic plumbing
lines, gas lines
or hot water pipes.
This appliance
must be installed
on a solid
floor and well leveled
due to the higher
spin speeds
available.
If installing
the
machine
on a wood
floor over a
basement
or on a second
floor,
the floor
may need to be
reinforced.
Sound,
vibration,
and
risk of "walking"
will be affected
depending
on the structure
and
stability
of the floor surface
where
it is installed.
If the washing machine is to be
installed on a weak wood floor
consider the following:
Soft floor surfaces, such as
carpets or surfaces with foam
backing,
are not suitable.
If
possible,
place the washing
machine in a corner of the
room.
Screw a water resistant
wooden
board (at least 3/4"
thick) to the floor.
Closet
Sides
1/4" (6 mm)
Top
12" (305 mm)
Rear
2,5" (64 mm)
Front
1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom:
24 sq. in (155 sq. cm)
Removing
the
transport
bolts
All 4 transport
bolts must be re-
moved before using the ap-
pliance for the first time and must
be retained for any future trans-
port (e.g. when moving).
Release screws using the 1/2"
wrench
provided
until they can
be moved freely.
Publicidad
