Scheppach HS110 Traduccion Del Manual De Instrucciones Originale página 47

16. Troubleshooting
Fault
Blade dissolves after
switching off the
engine
Engine will not start
Motor will not work,
the fuse is active
Fire marks on the
cutting surface
Possible cause
To slightly tightened fastening nut
Failure mains fuse
Defective extension cable
Connections on motor or switch
not in order
Motor or switch faulty
Cross section of the extension
cable does not sufficienty
Overload by a blunt saw blade
Blunt saw blade
Wrong saw blade
www.scheppach.com
Remedy
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
see „Electrical connection"
Change saw blade
Sharpen saw blade (only by an authorised sharp-
ening service) or replace
Change saw blade
GB | 47