Publicidad
Idiomas disponibles
Idiomas disponibles
VHB436
Commissioning
■
Make sure there is no evident sign of damage to
the machine before starting work.
■
Before starting any operation, perform a complete
charging cycle of the battery pack.
The system safety officers must:
■
Prevent any improper use or manoeuvre.
■
Make sure that the safety devices are not removed or
tampered with.
■
Check that all maintenance operations are regularly
performed;
■
Make sure that no machine part (couplings, holes, etc.) is
modified to attach additional devices;
■
Make sure that only original Nilfisk spare parts are used.
The user shall be responsible for ensuring that installation
complies with the all relevant local provisions. The
equipment must be installed by qualified technicians who
have read and understood the instructions herein.
Charging method
■
Before plugging the machine into the electrical
mains, make sure that the nominal voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■
Plug into an outlet with a properly installed ground
contact/connection. Make sure that the machine is
turned off.
■
The plugs and connectors of the connection cables
must be protected against water sprays.
■
Check that the connection to the electrical mains
is correct.
■
Charge the machine only when the cables that
connect to the electricity mains are in perfect
conditions (damaged cables could cause electric
GB
shocks!).
■
Regularly check that there are no signs of damage,
excessive wear, cracks or ageing on the charging
cable.
When the device is charging, do not:
■
Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the cable).
■
The charging cable must be replaced by the
manufacturer's service centre personnel or by
equivalent qualified personnel.
When the machine is in charge, the vacuum motors are
disabled.
C505
CAUTION!
NOTE
CAUTION!
CAUTION!
CAUTION!
CAUTION!
The device should only be charged indoors and
protected from the elements.
CAUTION!
Do not charge the machine when the ambient
temperature is below 0°C.
CAUTION!
Water or other liquids entering the battery compartment
can cause possible death or property damage.
Do not use water to clean the battery module.
Never
place
containers
containers and the like) on electrical equipment.
The relative humidity inside the room should not
exceed 85%.
Do not clean the system with agents containing acid,
caustic soda, or solvents.
Charging the machine
To charge the machine battery, connect the supplied power
cable to the plug (8). The charging LED starts flashing and
charging is in progress.
Dry applications
The supplied filters and the bag (if applicable) must be
installed correctly.
CAUTION!
Comply with the safety regulations governing the
vacuumed materials.
6
with
liquids
(beverage
Figure 1
[ NOTE ]
Publicidad
