Nilfisk VHB436 Manual De Instrucciones página 21

Description of the machine
Machine Parts and Labels
Figure 1
1.
Identification plate:
code, serial number, EC marking, year of manufacture,
weight (kg)
2. Dust container
3. Dust container release lever
4.
Vacuum inlet
5. Vacuum gauge
6. Filter shaker lever
7. Warning plate
the operator's attention to the fact that the filter must be
shaken only when the machine is off (see par. "Shaking
the primary filter" as well).
8. Plug to connect the vacuum cleaner to an electrical outlet
for charging.
9. Control keyboard
10. Closing band
11. Electrical connector
This machine creates a strong air flow which is drawn in through
the vacuum inlet and blows out through the outlet.
Before turning on the machine, fit the vacuum hose into the
inlet and then fit the required tool on to the end part (refer to the
manufacturer's accessory catalogue or Service Centre).
The diameters of the authorized hoses are indicated in the
Technical data table.
The machine is equipped with a primary filter which enables it
to be used for the majority of applications.
In addition to the primary filter that retains the most common
dust, a secondary filter (absolute filter) can be installed.
This machine is equipped with an internal baffle plate which
subjects the vacuumed substances to a circular centrifugal
movement that makes them drop into the container.
Optional kits
Various optional kits are available for converting the machine.
On request, the machine can be supplied with optional kits
already installed. However, they can also be installed at a later
date.
Please contact the sales network for further details.
Instructions describing how to fit the optional kits and the
relative operation and maintenance manuals are supplied
together with the optional kits.
CAUTION!
Use only supplied and authorised genuine spare parts.
Accessories
Various accessories are available; refer to the manufacturer's
accessory catalogue.
Model
Use only genuine accessories supplied and authorised
by the manufacturer.
Packing and unpacking
Draws
All the dispatched equipment has been thoroughly checked
before being delivered to the haulage contractor.
On arrival, check the machine to see that it has not been
damaged during transport. In case of damage, immediately
lodge a complaint with the haulage contractor.
Dispose of the packing materials in compliance with the laws
in force.
Model
VHB436
(*) Weight with packing
Unpacking, moving, use and storage
To unpack the vacuum unit, remove the retainers with a
hammer and a screwdriver.
Also remove the fastening devices placed by the manufacturer
when packing, by using suitable tools.
Release the wheel brakes and remove the machine from the
supporting platform, by using a ramp that can provide adequate
capacity, and by driving the vacuum cleaner by the handle.
Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the machine is placed
on must be suitable for bearing its weight.
If the device is to work in a fixed position, allow wide space
around the device in order to ensure freedom of the movement
and allow the maintenance staff to operate with ease.
The manufacturer shall not be liable for any damages
caused to the machine during lifting, when the lifting
equipment supplied by the manufacturer is not used.
When several supporting platforms are provided, the
supporting platform to which the machine is anchored
must be handled with a forklift truck that can provide
adequate capacity. Then unpack the machine by laying
it down on a flat and horizontal surface that can provide
adequate capacity for the vacuum cleaner weight.
5
CAUTION!
Figure 3
A (mm) B (mm) C (mm)
1200 700 1700
CAUTION!
CAUTION!
VHB436
kg (*)
150
GB
C505