Publicidad
Idiomas disponibles
Idiomas disponibles
Measurements
1. Press the START button. All of the
display segments are displayed. Zero (0)
is displayed blinking briefly. The display
changes, as indicated in the figure at
the right, as the measurement begins.
The cuff starts to inflate. It is normal for
the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of
the display, during the inflation.
Note: If you wish to stop inflation at any time, press the
START button again
2. When inflation is complete, deflation starts
automatically and
the measurement is in progress. Once
the pulse is detected, the mark blinks with
each pulse beat.
Note: If an appropriate pressure is not obtained, the device
starts to inflate again automatically. To avoid re-inflation,
see "Measurement with Set Pressure".
3. The display measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed. The device
announces the measurement results.
The cuff exhausts the remaining air and
deflates completely
4. Press the START button to turn the
device off. After one minute of non-
operation, the device will turn off
automatically.
5. The reading is then stored into
memory. See "About Memory" for more
information.
blinks, indicating that
At heart level
All of the display
segments displayed
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
Pressure Rating Indicator
Pulse rate
Exhausts remaining
air automatically
Press
START
E-17
Publicidad
