A. COMMISSIONING
Insert the batteries supplied with the device as follows:
- Using a screwdriver, unscrew the screw of the battery compartment cover (A1) on the
back of the housing and open it,
- Place the 4 batteries in the compartment (A2) taking care to get the polarities right,
- Close the battery compartment cover and screw it to the housing.
B. PRESENTATION
(B1) Jaws with centering marks
(B2) Physical guard
(B3) Switch
(B4) Function keys
(B5) Display unit
(B6) Terminals
(B7) Trigger
C. THE DISPLAY UNIT
(C1) Display of the modes selected (keys)
(C2) Display of the measurement value and unit
(C3) Display of the MAX/MIN/PEAK
(C4) Type of measurement (AC or DC)
(C5) Display of the selected modes (switch)
(C6) Spent battery indication
(C7) Total three-phase power measurements
D. THE KEYS OF THE KEYPAD
(D1) Storage of values, disabling of display
Zero connection zéro ADC / AAC+DC
Compensation of the resistance of the leads in the continuity and ohmmeter function
(D2) Selection of the type of measurement AC, DC, AC+DC
Selection of single-phase or three-phase measurement
(D3) Activation or de-activation of the backlighting of the display unit
(D4) Activation or de-activation of the MAX/MIN/PEAK
Activation or de-activation of the INRUSH mode in A
(D5) Measurements of frequency (Hz), of the level of harmonics (THD)
Display of the powers W, VA, var and PF
(D6) Activation of the ΔREL mode – Display of relative and differential values
(1) only F402
(2) only F404 - F604
(3) only F406 - F606
ENGLISH
(3)
(3)
(2) (3)
(3)
10
(3)
mode
(3)
(3)
(2) (3)