Descargar Imprimir esta página

Infiniton PACPX45AW Manual Del Usuario página 38

Aire acondicionado portátil

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Whenever there is a problem with the appliance, check if you can solve it by following the tables below. If
the problem persists, contact customer service.
DESCRIPTION
The air conditioning does
not work.
Poor cooling performance. Air inlets / outlets are obstructed
The air conditioning is very
noisy.
Compressor does not
work.
Error code E1
Error code E2
Error code E4
Note: Any electrical repairs to this product must comply with local, state, and federal laws. Please con-
tact the Technical Support Center if you have any questions before performing any of the above steps.
before performing any of the above steps. Always disconnect the unit from the power source when ope-
ning the unit.
POSSIBLE CAUSE
No power on
The display shows "FL".
The room temperature is too
low.
The room temperature is below
the cooling temperature setting.
The air conditioner is not on an
even surface.
The room temperature is very high.
Internal circuit temperature sensor
error.
Error in the external temperature
sensor.
Error in the anti-freeze protection.
Reset the circuit breaker in the
power cable.
Turn off the air, drain the water
tank and restart.
The appliance should operate at
an ambient temperature be-
tween 7ºC and 35ºC.
Change the temperature setting.
Remove any foreign bodies that
may be obstructing the air inlets
/ outlets.
Place the air conditioner on a firm
floor and on a carpet.
Turn off the air conditioner and wait
3 minutes before turning it on again
once the ambient temperature has
decreased.
Switch off the appliance, let it cool
down and switch it on again. If the
error persists, contact your local
service centre..
Wait until the ambient temperature
is between 7ºC and 35ºC. If the error
persists, contact the official technical
service.
The heater temperature is too low
and the entire air conditioning sys-
tem is deactivated.
When the temperature exceeds 8°C,
the protection is released and the
previous operating state is restored.
38
English
SOLUTION
infiniton.es

Publicidad

loading