Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and cleaning
¡ATTENTION! Before servicing or cleaning, the portable air conditioner must be disconnected
from the mains.
Note: The exterior surfaces are susceptible to scratches and abrasions, so please follow the cleaning
instructions to achieve the best possible result without damage.
General cleaning
Clean the surface of the device with a soft, damp cloth. Do not use chemical reagents such as alcohol,
benzene and petrol, as they may damage the surface of the portable air conditioner.
Drainning
The air conditioner will show "FL" on the display, accompanied by a beep when the
water tank is full. Once the compressor stops, drain the water as follows:
1.
Unplug the portable air conditioner and unscrew the hose from the air outlet of
the unit.
2. Move the air conditioner to a clear place.
3. Remove the plug from the drain hole and using a rubber hose, drain all the water
into a container.
4. Replace the plug back into the drain hole.
5. Reinstall the air outlet hose and put the air conditioner back in place.
Cleaning the filters
The filter should be cleaned once every two weeks. If the indoor air quality is poor, it must be washed
more frequently or the performance of the appliance will be reduced because the filters may be clo-
gged. If the indoor air quality is poor, it must be washed more frequently or the performance of the
appliance will be reduced because the filters may be clogged. Follow the instructions below for cleaning:
Storage
If the portable air conditioner will not be used for a long time:
Remove the drain hole plug and run the fan mode (FAN) for 2 hours.
Then switch off and unplug the unit. After unplugging, remove the filters and clean them. Remove the
sealing kit and corrugated tube and store them in a safe place. Remove the batteries from the remote
control and wrap the entire unit in a plastic bag. Keep the entire air conditioner assembly in a cool, dry
place.
Keep the entire air conditioner assembly in a cool, dry place.
1.
Remove the grille covering the filter
2. Remove the filter
3. Clean the filter in lukewarm water (40°C
is recommended) or in water with neutral
detergent. If the filter is not so dirty, you
can clean it with the help of a hoover.
Note: Do not wash the filter at temperatures
above 40ºC or with abrasive and flammable
products such as alcohol, petrol and benzene.
alcohol, petrol and benzene. The filters should
be kept away from heat sources, as they
may become deformed. Never switch on the
appliance without the filters installed correctly.
39
English
Fig.9
infiniton.es
Publicidad
