Ganter Norm DIN 582 Instrucciones De Uso página 5

EN
Translation of the original operating instruction (de)
About this documentation
This documentation is intended for persons who are entrusted with the installation and
commissioning of the product.
The lifting eye nut DIN 582 is referred to below as the "product".
Your safety
This section describes basic safety requirements and important information about the safe
installation of the product.
Read the operating instructions and information carefully.
X
Follow the safety instructions and warnings in this document.
X
Only use the product if it is undamaged and in good working order.
X
Keep the documentation nearby at the location of use.
X
Retain the documentation for the entire service life of the product.
X
Also observe the current statutory regulations and other rules for accident prevention
X
and environmental protection.
Safety symbols
DANGER
WARNING
CAUTION
NOTICE
Symbols
–
.
X
Safety and hazard information
Improper installation, modifications or incorrect operation can cause injuries and
property damage.
The information under "Technical data" refers to the load capacity. If this information
–
is not provided, the product may not be used!
The surface where the product is screwed in must be flat and at a right angle to
–
the threaded hole where the bolt will be inserted. Maximum countersinking of the
threaded hole = nominal diameter of the thread.
When screwed in, the collar of the bolt must make firm contact (do not use
–
washers).
Usage temperature from –20°C to 200°C.
–
Make certain that you and others are not within the range of movement of the load
–
(danger area).
Suspended loads must be monitored.
–
Carry out a visual inspection before every use.
–
Proper use
The product is for lifting and moving loads.
–
The product may only be operated in accordance with the technical specifications.
–
The rated load indicated on the product may not be exceeded.
–
Foreseeable misuse
Any use that deviates from the intended use is considered misuse.
–
The product may not be used for loads beyond the indicated rated load.
–
The product may not be used to transport people and animals.
–
The product is not suitable for rotational movements while bearing a load.
–
User qualifications
The product may only be used by authorized and trained persons in compliance with
DGUV Rule 100-500 and the corresponding national regulations for use outside of
Germany.
Storage
Store the product only in the original packaging in a dry and protected environment.
X
Environmental conditions
The product may not be brought into contact with aggressive chemicals, acids or their
vapors. These are potentially harmful to the product and could cause damage and failure.
Product description
The lifting eye nut DIN 582 is primarily used as a load attachment point for permanent
fastening to components such as motors, switch cabinets and transmission boxes to
facilitate transport.
For switching between various objects for transport, such as large tools, lifting eye nuts
with the next higher thread diameter must be used. When used with multi-line lifting gear,
the rules specified in DIN EN 818-4, for example, must be observed.
The rated load capacity listed under "Technical data" is clearly marked on the lifting eye nut.
The rated load capacity applies to the least favorable load situation with respect to the load
types listed here.
Specification
Steel C 15 E
drop-forged
–
normalized
–
contact face machined
–
zinc-plated, blue passivated
–
Stainless Steel A4
non-rusting, A4
–
drop-forged
–
solution heat-treated
–
contact face machined
–
DANGER indicates dangers that lead directly to
death or severe injuries.
WARNING indicates dangers that could lead to
death or severe injuries.
CAUTION indicates dangers that could lead to
injuries.
Notice indicates dangers that could lead to
property damage.
Meaning
Warning about a source of danger
Lists
Instruction
Stainless Steel A2
non-rusting, A2
–
drop-forged
–
solution heat-treated
–
contact face machined
–
5