Craftsman 320.39597 Manual Del Operador página 13

4. Center the sanding belt over the rollers and the bottom plate, then push the
lock lever back to its original position to return tension to the belt.
ADJUSTING THE BELT
TRACKING (Fig. 4)
Fig. 4 Runs toward outside
When a new sanding belt is
installed, the sanding belt tracking
may need to be adjusted several
times as the belt becomes more
pliable with use. The sanding belt
will remain centered on the rollers
during use when the belt tracking
is adjusted correctly.
1. Hold the belt sander upside Knob
down, and then turn it on.
NOTICE: This position is for the purpose of adjustment only. Do not allow the
sanding belt to come into contact with a workpiece or any other object
during adjustment.
2. If the sanding belt runs inward toward the belt-tracking knob, rotate the belt-
tracking knob clockwise.
3. If the sanding belt runs toward the outside, turn the belt-tracking knob
counterclockwise.
DUST BAG (Fig. 5)
,_ WARNING: Do not use the
dust bag when sanding metal.
Using the dust bag when sanding
metal creates a fire hazard, which
could damage the tool and lead to
serious personal injury. Your belt
sander is supplied with a dust bag
to help you keep the working area
clean.
Fig. 5
Dust-exhaust
port
Buckle Dust
To install:
1. Disconnect the belt sander from the power source.
2. Align the dust-exhaust port with the dust bag outlet.
3. Push the dust bag onto the tool until the buckle of the dust bag snaps onto the
dust-exhaust port firmly.
NOTICE: From time to time, clean the dust-exhaust port with a dry brush.
13