Publicidad
Idiomas disponibles
Idiomas disponibles
• lock release codes (numeric ONLY:1-99999999)
Permit direct opening of the door by residents
or by authorized persons; these codes must
always be preceded and followed by pressing
of the 'Key' key. Initial pressing of the 'Key' key
prevents display of the lock release code in which
the digits are replaced with asterisks:
LOCK RELEASE CODE
The lock release codes can be inhibited in pre-
established time bands using an external timed
switch that operates on the 'H' and '0V' terminals.
• special codes (1-999)
Can be used to activate/deactivate auxiliary services
such as the stair lights, garden lights etc. Must always
be preceded by a '0' (which prevents display of the
codes) and followed by pressing of the 'Call' key:
SPECIAL CODE:
These codes also make it possible to check the
status of an input showing this on the display with
the 'On' or 'OFF' caption; for example:
TERMINAL STATUS:
For further information refer to the Ref. 1038/80
Special Decoding box User Manual.
NOTE: In the case of an error during entry of any
code, press the 'X' cancel key: the code
shown on the display will be cleared.
PROGRAMMING OF DECODING BOXES
The 1038/14 Call Module with Repertory can be
used by the installation technician to program
the decoding devices. For a description of the
parameters and programming methods, refer to the
decoding boxes User Manual.
In any case, if a parameter is programmed
successfully, the display of the module will show:
Programming
Otherwise, the following message is displayed:
Programming
4
********
0***
ON
OK
KO
PROGRAMMING
PROGRAMMING METHODS
The Call Module with Repertory can be programmed in
three different ways (in any case only when powered):
1) Programming
Programming Terminal. This programming
method is recommended as the display of the
terminal facilitates the operations involved. The
terminal may be connected:
.
− locally on the programming connector (2) to
the Call Module to be programmed.
.
− on any other Call Module or Main Entrance
Switchboard included in the system.
2) Locally via keyboard without having to open
the frame of the Module. In this case, the
configuration access password must be known.
3) Locally via keyboard opening first of all the
frame of the Call Module to press the rear
programming button (4).
PARAMETERS
The following parameters must be programmed:
A) The operating language
One of the listed languages can be selected in
three consecutive screen forms.
B) Description of the installation site
This is a 15-character string that must be used
to assign the Call Module a mnemonic name:
e.g. 'Entrance V. Roma', 'Corso Venezia',
'Stair A', 'Stair B'. In actual fact, it is possible
to insert up to 30 characters but, in the fast
search phase, only the first 15 will be shown. It
is advisable therefore to restrict the name to 15
characters and to use the remaining characters
for.any.additional.information.
using
the
Ref.
DS1038-030
1038/56
Publicidad
