Urmet Digivoice Sinthesi S2 1038/14 Manual De Instrucciones página 31

Saving of the Database on the PC
Using the DVOICE program, create a new site
on your PC and save the names of the residents
together with any other relative information (such
as for example the lock release codes). For further
information, refer to the DVOICE program.
Transfer of the Database from PC to the 1038/56
Terminal
− Connect the programming Terminal to the selected
serial port of the PC using the specific cable
provided.
− set the DVOICE program to download the
Database of the site on the Terminal.
− Switch on the terminal. The following message is
displayed:
To program
connect cable
<Configur.>
<Database> <PC>
− Select <PC> and press ↵. The following message
is displayed:
<PC-TP>
<TP-PC>
<Exit>
− Select the <PC-TP> item, press ↵ and answer YES
to the subsequent confirmation prompt: transfer of
the Database from PC to Terminal will start.
− On completion of transfer, return to the main
page, switch off the terminal and disconnect the
cable from the PC.
Checking and Modification of the Database
Once the names Database has been loaded on the
terminal, it can be examined and modified. To do
this, access the <Database> item from the main
page and then select one of the possible options:
<Display>
<Insert>
<Modify>
<Cancel><Exit>
DS1038-030
Transfer of the Database from the 1038/56
terminal to one or more 1038/14 Call Modules
− After establishing the logical connection with
the Call Module concerned (see description in
the 'PROGRAMMING USING THE 1038/56
TERMINAL paragraph'), go to the following page:
<Names>
<Lock release>
<Program>
<Cancel><Exit>
− Select <Names> and press ↵. The name
Management menu is displayed:
<Insert>
<Modify>
<Cancel><Exit>
<REP-TP><TP-REP>
− Select <TP-REP>, press ↵ and answer YES to
the subsequent confirmation prompt: transfer of
the Database from the Terminal to the Module
selected is started.
− Once transfer has been completed disconnect
the cable and switch off the terminal pressing the
'OFF' key for at least 3 seconds, or if the same
database is to be programmed on another call
module in the system repeat the steps described
above.
NOTE: in the case of a database with many names,
transfer may take a number of minutes. A
horizontal square bar will indicate state of
completion.
Transfer of a names Database from one Call
Module to another (or to a PC)
To 'copy' the names from one call Module to another,
use the Terminal. Establish a logical connection
with the first Module (that from which the names are
to be copied) and select first of all <Names> and
then <REP-TP>: the names database will be copied
on the terminal. At this point, it can be downloaded
on another call module or, changing the cable of the
Terminal, on PC.
31