Joining and attaching the drag arms
2
Tightening the chain
Lubricating the guide-track
5
A
B
P278J
5
2
A
P278J2
A
B
P278K
For sectional and tilting doors with side springs:
1 Attach the door anchor (2) to the carriage (5) using
the drag arms (A) and (B).
For counterbalanced doors or with torsion
springs:
1 Attach the NPTOR curved fitting (2) to the carriage
(5) using the drag arm (A), in accordance with the
installation instructions for the NPTOR fitting.
1 Tighten the nut (A) and then loosen it slightly until
the bushing (B) can be turned by hand.
2 Check that the chain is taut by carrying out several
opening and closing cycles of the door.
Excessive tautness may lead to breakage or
premature deterioration of the parts.
If the chain is loose, a noise will be heard when
closing the door.
1 Apply lubricant grease throughout the length of the
carriage-track contact area.
NAOS garage door opener operator
INSTALLATION
49