Adler europe AD 3066 Manual De Uso página 5

BEFORE FIRST USE
1. Remove the packaging and any stickers and accessories that are outside and inside the device - between the heating plates
(4a,4b)
2. Wipe the heating plates (4a, 4b) with a damp and then a dry cloth.
3. Close the device and connect it to the power supply - the power indicator (2) will turn on.
4. Leave the device turned on for a few minutes to get rid of the factory smell. During this time, the device may emit a small amount
of smoke. This is normal.
5. Clean the device according to the "Cleaning" section of this manual.
USING THE DEVICE
Prepare the necessary products.
1. Connect the closed device to a grounded power socket - the power indicator (2) will light up.
2. Wait about 3 minutes for the device to warm up to the correct temperature. Then the indicator light will turn off (2).
3. Open the device completely and place the previously prepared food on the lower heating plate (4a).
4. Close the device. Lock the locking clip (3) Do not close the lid (1) by force.
5. During the operation of the device, the thermostat indicator light (2) will turn on and off, which means that the thermostat
maintains the temperature of the heating plates.
6. The processing time of the products is on average from 5 to 20 minutes and depends on the ingredients used and taste
preferences.
It is recommended to turn the device 180˚ at least once during food preparation, for this purpose the device has rubber feet on both
sides. During this operation, the device must be closed with the locking clip (3). The device should be rotated holding only the
handle (5), special care should be taken during this operation.
ATTENTION! Hot steam may escape from under the lid of the appliance when processing food.
7. Fully open the upper cover (1) of the device and remove the finished products using only a wooden or plastic spatula.
ATTENTION! Do not use metal cutlery or sharp kitchen tools as they may damage the special non-stick coating of the heating
plates.
8. Before starting the preparation of the next batch of products, close the device to allow the heating plates to heat up to the right
temperature.
9. After cooking, remove the plug from the main socket and leave the appliance to cool down.
CLEANING THE DEVICE
1. Before cleaning the device, remove the plug from the main socket and wait for the device to cool down.
2. Clean with a damp and then a dry cloth (or a paper towel).
3. Apply a small amount of cooking oil to the stubborn residues and after a few minutes gently remove them with a wooden spatula.
4. Do not clean the heating plates with sharp, abrasive cloths or sponges, or use cleaning powders, as they may damage the
smooth, non-stick coating of the plates.
5. Do not immerse the device in water.
TECHNICAL DATA
Supply voltage: 220-240V ~50/60Hz
Nominal power: 750W
Maximum power: 900W
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
SICHERHEITSBEDINGUNGEN WICHTIGE ANWEISUNGEN ZUR SICHERHEIT DER
VERWENDUNG BITTE SORGFÄLTIG LESEN UND ZUM SPÄTEREN
NACHSCHLAGEN AUFBEWAHREN
Bei gewerblicher Nutzung des Gerätes gelten abweichende Garantiebedingungen.
1. Bevor Sie das Produkt verwenden, lesen Sie bitte die folgenden Anweisungen
sorgfältig durch und befolgen Sie diese stets. Der Hersteller übernimmt keine Haftung
(DE) DEUTSCH
5