Calling from a remote phone
You can call from a pushbutton (tone) phone and "pick up" messages
recorded on the answering machine, using the control codes for
remote operations.
In order to operate from a remote phone, you must first set the
security code (see page 17 for the setting operations).
1
Call your phone number from a pushbutton
phone.
i
If you make a mistake, you can
try again, up to three times
before you will be disconnected.
Also, If you do not enter the
security code within 20 seconds,
you wiB be disconnected too.
2
When you hear the greeting, press
<D,
then enter
your security code.
The one-digit security code must be entered within two
seconds.
Example
: II your security code rs
8,
press &), then <D.
You hear a long confirmation beep, and the greeting stops.
The number of messages recorded on the answering
machine will be announced. Depending on the recorded
messages, the answering machine operates as follows:
If there are:
then the answering machine:
new messages (messages
that have not been played
back)
plays back the messages
automatically.
only old messages
(messages that already have
been played back)
stands by for you to enter a
control code.
no new or old messages
stands by for you to enter a
control code.
I
•
If 20 seconds elapse without
pressing a control code, the call
will be disconnected.
3
if you want to continue with another operation,
enter the control code within 20 seconds (see
page 29).
4
Hang up when you finish.
■ Forget-to-set feature-
If you left home and later realized that you forgot to turn the
answering function on, you can turn it on by calling the answering
machine and letting it ring for 10 rings. The answering machine
will automatically answer a call after 10 rings even if the
answering function is off. The answering function will remain on
for all subseouent calls.