B+B Centuro S2 Manual De Instrucciones página 30

Centuro S2 / S1
| Scooter
5.4.4.
The arm rests can be swivelled upwards in order to make it easier to
mount and dismount. In addition, the height, distance and angle of sup-
port of the arm rests can be adjusted.
10
Height
• Undo the hand screw until you can pull it out, and hold the screw in
position. The armrest can now be adjusted upwards or downwards
(Fig. 10).
• Move the armrest to the required height and tighten the screw again.
Side distnace
• Undo the hand screw (Fig. 11) on the back of the back rest frame
while holding onto the armrest.
11
• Adjust to the required distance and tighten the screw again.
• The armrests can also be removed (e.g. for replacement, storage or
transportation) after undoing the screw on the back of the frame (Fig.
11).
Angle of support
• You can adjust the angle of support of the armrests by screwing the
knurled nut (Fig. 12) on the relevant armrest further in or by unscrew-
ing it.
12
5.4.5.
The seat belt will be attached to the frame from the side.
• Adjust the belt length to meet your needs by positioning the clasp
accordingly.
• Fasten the belt with the belt buckle.
• Unfasten the belt by pressing the red button (Fig. 12) on the belt
13
buckle.
58
Armrests
Seat belt (optional)
6. Operating the scooter
After you have adjusted the scooter according to your height, familiarise
yourself with the functions of the controller.
6.1. Control Functions
The controller is a component of the steering column of your scooter. It
contains LED displays and functional elements.
Hazard warning lights
Use this button (Fig. 15) to switch on the hazard warning lights in emer-
gency situations where it is not possible to drive the scooter. All four
indicator lights then flash and signal to other road users that your scooter
cannot be driven.
Bischoff & Bischoff GmbH |2023.12.12 - Rev. 3
Centuro S2 / S1
Scooter |
14
15
59