Publicidad
Idiomas disponibles
Idiomas disponibles
PACKAGING CONTENT
Air purifier:
Remote control:
Hook bolt:
Hold-down hook bolt:
Hold-down chain:
Manual and warranty
TOOLS FOR ASSEMBLY
No.1 cross screwdriver, one 10 MM open
end wrench Except normal replacement of
filters, the air purifier does not need too
much assembly work. You only need to
remove the back cover for process. The
machine can be put on the desk or hang on
the ceiling, or used for air ventilation hole or
cold/warm air hole to filter wood dusts of
the woodworking sawing machine in the
working area/or other tools. (not flitters)
info@altonindustries.com
ABOUT INSTALLATION
Notice
1 PC
1 PC
The lifting hook must be anchoring on the
building structure, with each screw
4 PCS
supporting at least 100 pounds. Do not
4 PCS
install the hook on the ceiling surface or
4 PCS
ceiling grids, and be mindful of drops.
1. Take out the air purifier machine and
internal installation accessory screws,
hooks, connecting chains, and hold-down
hooks from the package.
2. The air purifier is hung on the ceiling.
Remove the four screws form the top of
the cabinet (A, figure). 1)
3. Use four hook screw hanging devices
(B, figure) and four hex nuts.
4. Screw the hook into the cabinet, and
use the open end wrench to tighten the
nuts (C, Figure. 1).
5. Repeat the operation for the other three
lifting bolts.
6. Drill four holes on the ceiling with the
same distance of the four hooks on the
cabinet, install the hooks, and use chain to
connect the air purifier system.
Note: The installation height of the air
purifier is about 10 feet above the ground,
and the height can be adjusted by the
chain.
06
Publicidad
