Publicidad
Idiomas disponibles
Idiomas disponibles
Section4: Operation
4,
Place the small filter end of the detergent
siphoning
tube into the detergent
container.
CAUTION!
Keep the chemical injection tube from
coming in contact with the hot muffler,
5.
Make sure the black spray tip is installed..
NOTE:
Detergent cannot be applied with the high
pressure spray tips (White, Green,Yellow, or Red),
6o Hake sure the garden hose is connected to the water
inlet. Check that the high pressure hose is connected
to the spray gun and the pump and start the engine,
7,,
Apply the detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strol<es..
8.
Allow the detergent to soak in between 3-5 minutes
before washing and rinsing_ Reapply as needed to
prevent surface from drying. DO NOT allow the
detergent to dry on (prevents streaking)..
IMPORTANT:You
must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in tow pressure
for I-2 minutes.
Pressure
Vv'asher
Rinsing
_
ARNING!
Be extremely careful if you must use
the pressure washer from a ladder, scaffolding or any
other relatively unstable location, When you press
the trigger, the recoil from the initial spray can be
very strong,The high pressure spray could cause you
to fall if you are too close to the cleaning surface,,
Wash and Rinse Surface
This pressure washer permits regulation of output water
pressure by varying the engine speedThe
variable pressure
control lever found on the front of the engine may be set,
as shown in Figure 16:
Pressure
Low
to
Hig h
DU_
Light
Medium
Heavy
Application
Auto
Concrete
Paint removal
Boat
Driveway
Degreasing
Furniture
Deck
,
3.
After
you
have applied
detergent,
scour
the surface
and
rinse
it clean
as follows:
1,
Apply
safety latch to spray gun,,
Remove
the black chemical
nozzle
from the nozzle
extension,
4r
5,
Select and install the desired high pressure nozzle
following the instructions "How to Use the Spray Tips"
on page l0
Keep the spray gun a safe distance from the area you
plan to spray,
Adjust the spray pressure by sliding the variable
pressure contol lever left or right, as shown in Figure 12
on page 8.
_
AUTION!
Firmly grasp spray gun with both
hands when using high pressure spray to avoid
injury if gun kicks back..
6_ Apply a high pressure spray to a small area and then
check the surface for damage, if no damage is found,
you can assume it is okay to continue rinsing_
7,. Start at the top of the area to be rinsed, working
down with same overlapping strokes as you used for
cleaning.,
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a temperature
between t25 °-155°EAt
this temperature, the system
engages and cools the pump by discharging
the warm
water onto the ground. This system prevents internal
damage to the pump_
Publicidad
