Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPARING
THE
UNiT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump acrJon,If you do not plan to use the pressure
washer for more than 30 days,follow this procedure:
I,
Flush detergent siphoning tube by placing the filter into
a pail of clean water while running pressure washer in
low pressure mode Flush for one to two minutes
Z
Shut off the engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark pEugwire
from spark plug
3.,
4_
Empty the pump of liquids by pulling the engine recoil
handle about 6 times,This should remove most of the
liquid in the pump,
Use pump saver to prevent corrosion build up and
freezing of pump,,
Store unit in a clean, dry area.
Protecting
the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump, This
prevents freeze damage and lubricates pistons and seals,
NOTE:
PumpSaver, model number 01559, is available as an
optional accessory_ It is not included with the pressure
washer,,Contact the nearest authorized service center to
purchase PumpSaver.
CAUTION!
You must protect your unit from freezing
temperatures. Failure to do so will permanently damage
your pump and render your unit inoperable. Freeze damage
is not covered under warranty,
_
CAUTION!
Read and follow all cautions and
warnings on the PumpSaver can label Always wear
eye protection when using PumpSaven
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water, Read and
follow all instructions and warnings given on the PumpSaver
container,
NOTE:
PumpSaver will drip from pump after treatment
and will stain wood and concrete,
NOTE:
If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice
STORING
THE
ENGUNE
See the engine owner's
manual for instructions
on how to
properly
prepare
the engine for storage_
Publicidad
