Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
,_
WARNING!
NEVER fill fuel tank completely full.
Provide space for fuel expansion Wipe away any fuel
spillage from engine and equipment before starting°
. Place pressure
washer
on a level surface,
. Refer to the engine owners
manual to add recommended
fuel to engine,
Connect
Hose
and Water
Supply
to
Pump
IMPORTANT:
To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine,
NOTE'-Your
pressure washer comes with a quick connect
that you can use to attach the high pressure hose to either
the spray gun or pump,
I.,
Uncoil the high pressure hose and attach the female
quick connect to one end of the hose,Attach the male
quick connect to the gun (Figure 7)
2,
Attach the end of the hose to the base of the spray
gun (Figure 7)._ Pull down on the collar of the quick
connect, slide fitting into the pump and let go of collar.
Pull on hose to be sure of a tight connection.
NOTE: The quick connect is shown connecting the high
pressure hose to the spray gun If you choose to use the
quick connect for the hose to pump connection, follow the
same directions to attach quick connect from hose to pump.
3_ Attach the other end of the high pressure hose to the high
pressure outlet on the pump (Figure 8).Tighten by hand,
,.
Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 9), Clean the screen if it
contains debris, replace it if it is damaged DO NOT RUN
THE PRESSUREWASHERIFTHE SCREEN IS DAMAGED.,
Inspect
inlet
screen,
DO
NOT
use if
if dirty_
5.
Run water through the garden hose for 30 seconds to
clean out any debris Turn off water,,
IMPORTANT:
DO NOT siphon standing water for the
water supply, Use ONLY cold water (less than i 00°F),_
6.
Connect the garden hose (not to exceed 50 feet in
length) to the water inlet,Tighten by hand (Figure 9)
CAUTION!
There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector or other convenience-type water shut-off valve,
Damage to pressure washer resulting from disregarding this
caution will not be covered by the warran_
7,
Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
._
CAUTION!
Before starting the pressure washer,
be sure you are wearing adequate eye protection
Checklist
Before
Starting
Engine
Review the
unit's
assembly to confirm you have performed
all of the following:
I,
Make sure the handle is in place and secure,,
2_ Check that oil has been added to the proper level in
the engine crankcase,
3_ Add the proper fuel to fuel tank.,
4,.
Check for properly attached hose connections,
5,, Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
6,
Provide a proper water supply at an adequate flow
7,, Be sure to read"Safety Rules" and "HowTo
UseYour
PressureVVasher" before using the pressure washer.
Publicidad
