Troy-Bilt 01904 Manual Del Propietário página 6

Section 3: Assembly
2 Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray°
3 Place the handle assembly onto the handle supports
connected to the main unit_ Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2)
NOTE: It may be necessary to move the handle supports
from side to side in order to align the h_ndle so it will slide
over the handle supports.
4. Insert the"L" bait through the hole on the left side of
the handle (viewing from handle side of unit) and attach
the plastic knobTighten the knob by hand (Figure 3),
5. insert the carriage bolt through the right side hole
from the outside of the unit and attach a plastic knob
from the inside of the unit (viewing unit from the
handle side) Tighten by hand (Figure 3),
6.. Insert the "J" hook into the second from the left slot in
the accessory tray (Figure 4),
7. Pinch the chemical hose and slide it into the metal clip
as shown in Figure 5_
8. Tilt the unit up by the handle and attach the metal clip
to the rib on the center underside of the accessory
tray (Figure 6). Slide the chemical hose through the
metal clip so that it is tight but not kinked,
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure,
• Place pressure washer on a level surface
- Refer to the engine owners manual to add recommended
oil to engine,.
NOTE= Check oil often during engine break-in,. Refer to
engine owner's manual for recommendations..
Add Fuel
WARNING! NEVER fill fuel tank indoors, NEVER
fill fuel tank when engine is running or hot, Allow
unit to cool for two minutes before refueling, DO
NOT Iight a cigarette or smoke when filling the fuel
tank,