Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
Make sure that the latch in the
battery compartment(s) snaps into place
and that the battery pack(s) are secured
to the unit before starting operation.
4. Attach the other battery pack into
the other battery compartment in
the same way.
5. To detach the battery pack,
depress the battery-release button
to release the battery pack, and then lift it out of the compartment (Fig. 10b).
6. Close the battery pack compartment cover.
WARNING:
use.
STARTING/STOPPING THE PRESSURE WASHER (Fig. 11)
To Start the Pressure Washer
NOTICE:
Do not start the pressure washer without water supply connected and
turned on. This may damage the high-pressure seals and decrease pump life.
1. Ensure that the siphon hose, high-pressure hose, gun, nozzle are connected
properly.
2. Connect lance, wand, foam cannon, filter according to your needs.
3. Choose one of below water supply ways:
◾
When using a garden hose (not provided), connect the pressure washer to
the garden hose and then open the water faucet.
◾
When using a water bucket, connect the filter to the siphon hose and then
immerse the filter and the quick-coupler joint fully into the water bucket.
4. Install the battery pack(s) into the pressure washer.
5. Press the power button to power on the pressure washer. The washer will always
run at high speed after each start.
26
56-VOLT LITHIUM-ION PRESSURE WASHER — HPW3200/HPW3200-FC
Always remove the battery pack when the pressure washer is not in
10b
Battery-Release Button
b
a
Publicidad
