Craftmade Daybreak Guia De Instalacion página 7

7. Fan Assembly.
Remove motor assembly from j-hook on
mounting plate. Then, raise motor assembly to
mounting plate again, aligning holes in top plate
of motor assembly with screws in mounting
plate. Re-insert the 4 flat washers and 4 lock
nuts previously removed (page 5, Section 4) to
secure motor assembly. Tighten all 4 lock nuts.
[Refer to diagram 1]
Note: Gap on top of motor assembly must align
with j-hook for the proper fit. Make sure wires
and wire connectors do not get tangled or
pinched between the plates.
Raise motor housing to mounting plate, aligning
4 metal bars on the inside edge of motor
housing with 4 posts on edge of mounting plate.
Twist motor housing to the RIGHT to lock.
[Refer to diagram 2]
WARNING: It is important that you make sure to
turn the motor housing all the way to the right
to ensure that the motor housing is completely
secure.
Locate 5 center band screws/washers in
hardware pack. Insert tabs and align holes in
center band with screw holes in motor assembly,
allowing motor plate to come through hole in
middle of center band. Insert screws/washers
and securely tighten all 5 screws/washers with a
Phillips screwdriver. [Refer to diagram 3]
flat washers
lock nuts
diagram 1
post
metal
bars
(inside)
diagram 2
molex
connections
diagram 3
page 7
mounting plate
motor
assembly
mounting plate
motor
housing
motor assembly
center band