Craftmade Daybreak Guia De Instalacion página 8

8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Locate 3 blade plates and 9 blade attachment
screws/washers in hardware pack. Slide a blade
through one of the narrow, rectangular openings
on the center band, aligning holes in blade with
holes in blade arm located on the underside of
the center band -- refer to drawing at right. Hold
1 blade plate up to a blade, and align holes as
shown. Insert 3 blade attachment screws/washers
with fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
each remaining blade.
NOTE: Tighten blade attachment screws twice a
year.
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor assembly and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from
motor assembly to come through holes in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter
plate and partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to
WHITE wire from motor assembly. Connect
BLACK wire from LED light kit to BLACK (or
BLUE) wire from motor assembly. Be sure
that molex connections snap together
completely.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Align grooves on shade with nodules on
inside of LED light kit and push up gently on
shade. Twist shade to the RIGHT (clockwise)
until shade locks into place.
Note: Pull down VERY GENTLY on shade to
make sure that shade is secure.
(view from underside)
blade arm
motor plate
molex
connections
molex
connections
shade
page 8
center band
blade
blade plate
blade attachment
screws/washers
fitter plate
LED light kit
nodules
grooves