cecotec BOLERO DRESSCODE 7000 DN Manual De Instrucciones página 36

ENGLISH
Connection between the washing machine connector and the water supply hose.
1. Align the curved part of the hose and the washer connector (inlet valve) on the back of the
product as shown in figure 7.
2. Tighten the compression nut by turning clockwise.
Connection between a screw tap and the water supply hose
Screw tap and water supply hose.
3. Align the other end of the water supply hose and the threaded tap and tighten the
compression nut tightly by turning clockwise. Check figure 8 for reference.
Drain hose
Note
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
- In a drainpipe. It is recommended to use a vertical tube. Fig. 9
- In a sink's drainpipe, over the trap. Fig. 10
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operation.
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
- All washing machines are thoroughly checked before leaving the factory and undergo
quality control. There may be a small amount of residual water in the drum. To remove it,
as well as to neutralise possible odours, it is recommended to clean the drum before the
first use. You can run a "Cotton" programme at 90°C without laundry and detergent.
70
BOLERO DRESSCODE 7000 DN
QuickStart
Before washing. Fig. 11
1. Plug the appliance into a power supply.
2. Open the water supply tap.
3. Load the washing machine with the laundry.
4. Close the door.
5. Add detergent (and softener if necessary).
Note
Make sure that the washing machine is properly installed before use.
Washing. Fig. 12
1. Turn the knob to select the desired programme.
2. Select function or use the default one.
3. Press Start.
After washing
The "Start/Pause" lights will flash and a beep will sound or two small dots will flash on the
display.
Using the washing machine
Before each washing
- The washing machine should be operated within a temperature range of 5-40 °C. If used
under 0°C, the inlet valve and draining system may be damaged. If the machine is placed or
operated in rooms at 0 °C or below, it should be transferred to normal room temperature
to ensure the water supply hose and drain hose are not frozen before use.
- Check the care labels and the product instructions when using detergent before washing.
Use non-foaming or less-foaming detergent suitable for machine washing.
- Check the label. Fig. 13.
- Empty the pockets of the clothes to be washed. Fig. 14.
- Knot the long strips, close zips or tighten button. Fig. 15.
- Place small items in washing bags. Fig. 16.
- Turn easy-pilling and long-pile fabrics inside out. Fig. 17.
- Separate clothes with different textures.
Note
Washing loose laundry can cause imbalances in the washing machine. It is advisable to add
more laundry to ensure optimum performance (maximum ¾ parts of the drum).
ENGLISH
71
BOLERO DRESSCODE 7000 DN