Whittier Wood Furniture Riverside 157Wa Instrucciones De Ensamble página 2

157Wa Riverside Counterstool – Parts List
Please identify the parts and check that quantities received match those on this list.
If you need to replace a part, refer to the following letter and model name.
PART DESCRIPTION
A Sea ................................................ 1 t
B Back .............................................. 1
CC Left Leg ......................................... 2
DD Right Leg ....................................... 2
E Left Back Post ............................... 1
F Right Back Post ............................. 1
G Back Spindle ................................. 3
HH Short Side Stretcher ...................... 4
I Long Side Stretcher....................... 4
Assembly Instructions
3/32" and 1/8" drill bit and Drill, slow-drying glue, Adjustable Wrench.
Use a slow-drying glue. Once you start gluing the
Do not allow children to use this stool without adult supervision.
1. Place the seat upside-down on a clean, protected surface. Turn the top of the Swivel (J) approximately
1/8 turn in relation to the bottom of the Swivel. Center the Swivel on the bottom of the Seat (A) as
shown in Figure 1. The holes for the screws in the Swivel will line up with the indentations on the seat.
Remove the Swivel and, in the middle of each indentation, drill a 1/8" diameter pilot hole 1/2" deep.
Do not attach the Swivel at this time.
157Wa — Page 2 — 10/13
QTY.
Tools Required: Rubber Mallet, Phillips Screwdriver,
IMPORTANT:
stool together, continue until complete.
J
Fig. 1
PART DESCRIPTION
J Swivel ..........................................1
K
#8 x 2" Black Screw.....................2
L
#12 x 1" Pan Head Screw ...........4
M
5/16" Flat Washer........................4
N 5/16" x 3" Lag Bolt .......................4
#8 x 1-1/4" Black Screw ..............8
O
P Wood Wedge...............................2
Wood Button................................2
Q
A
QTY.