Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING
YOUR WASHER
STEP 1
Selecting
a location
_
Before you install the washer, make sure the location:
•
Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
Has no dust or alien substances.
Is away from direct sunlight.
Has adequate ventilation.
Will not be freezing (below 32 °F or 0 °C).
Is away from heat sources such as oil or gas.
Has enough space so that the washer doesn't stand on its power cord.
STEP 2
Removing
the Shipping
Bolts
Before using your Washer, you must remove the four shipping bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fillthe holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
settng up your washer 15
WF210AN-02832A
ENindd
15
2010-02-09
o&,,f1:14:58
Publicidad
