Publicidad
Idiomas disponibles
Idiomas disponibles
G ETTi NG STARTE D
1. Load your Washer.
2. Close the door.
3. Press the Power button.
4. Add detergent and additives to the dispenser (see pages 20-21).
5. Select the appropriate cycle and options for the load (see pages 18-19).
6. Press the Start/Pause
Button.
7. The Wash Indicator light illuminates.
8. The estimated cycle time appears in the display.
The time may fluctuate to better indicate the time remaining in the cycle.
The actual time required for a cycle may differ from the estimated time in the display depending on the
water pressure, water temperature, detergent, and laundry.
9. Before your washer starts to fill, it will make a series of clicking noises to check the door lock and do a
quick drain.
o
When the cycle is complete, the Door Lock light goes out and "End" appears in the display.
DO NOT attempt to open the door until the Door Lock light is off. To add a forgotten item, see
"Loading your Washer" section. (page 19)
When your Washer is restarted after a pause, expect a delay of up to 15 seconds before the cycle
continues.
Pressing Power cancels the cycle and stops your washer.
The Wash, Rinse and Spin indicator lights illuminate during those portions of the cycle.
washng a oad of aundry
19
WF210AN-02832A
EN.indd
19
2010-02-09
oo, f1:15:03
Publicidad
