Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 3
Installing
your Washer
1,
Place the drain hose in the drain facility (tub,
sink, or standpipe.) If you connect the drain
hose to a standpipe, be sure an airtight
connection is NOT made between the drain
hose and the standpipe. The standpipe
must be at least 18 inches or 46 cm high
and no higher than 96 inches.
®
Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way - by
elbows, couplings, or excessive lengths.
For situations where the drain hose
cannot be conveniently elevated to at
least 18 in or 46 cm, the drain hose must
be supported.
Laundry tub
Stand pipe
_°_°
re alner
96" Max
"
in
Tie strap
2. Before connect the inlet hoses to water faucets, check to
ensure a washer is inside each coupling on both ends.
Couplin£
I Rubber
Washer
3,
Check the inlet hose to ensure a washer is inside each fill
hose coupling.
Thread the inlet hoses to the HOT and COLD faucet
connections on the washer.
On the other end of the hose, check for one rubber washer
per hose and attach each fill hose to the water valve. Make
sure the hose with the Hot printed line is attached to the
HOT faucet. Tighten by hand until snug, then two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an "nF" (no fill)
error can occur.
Cold
Hot
16 setting up your washer
WF210AN-02832A
EN.indd
16
2010-02-09
o_,,,f1:15:00
Publicidad
