RIDGID R42223 Manual Del Operador página 12

FEATURES
SWITCH
SELF-RETRACTING LOWER BLADE GUARD
TRIGGER
TRIGGER
LOCKOUT LEVER
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SLIDE BAR
When unlocked, the saw arm will glide forward and back-
ward the length of the slide bar for cutting various workpiece
widths.
SPINDLE
LOCK
SLIDE LOCK KNOB
BUTTON
SLIDING MITER
The slide lock knob locks and unlocks the sliding feature
FENCES
of this tool.
SLIDING MITER FENCES
See Figure 6.
The sliding miter fences help support the workpiece se-
curely when making most cuts. The sliding feature allows
for clearance of the saw blade when making bevel or com-
pound cuts. Some cuts may require that the sliding fence
be removed completely to avoid interference between the
fence and the blade.
Loosen the fence lock knob before attempting to slide the
fences or lift them for removal. Once the desired position
of the fence is determined, retighten the fence lock knob
securely.
SPINDLE LOCK BUTTON
SWITCH
See Figure 6.
TRIGGER
The spindle lock button locks the spindle (keeps the saw
blade from turning). Depress and hold the lock button only
PADLOCK
while installing, changing, or removing the saw blade.
SWITCH TRIGGER
See Figure 6.
The saw will not start until you depress the trigger lockout
lever and squeeze the switch trigger. To prevent unauthor-
ized use of the compound miter saw, disconnect it from
the power supply and lock the switch in the OFF position.
To lock the switch, install a padlock (not included) through
Fig. 6
the hole in the switch trigger and make certain the switch
is inoperable. If the switch is still operable with the padlock
installed, a padlock with a larger shackle diameter must be
used. Store the padlock key in another location.
12 - English