RIDGID R42223 Manual Del Operador página 20

ASSEMBLY
 Lift the miter lock lever to unlock the miter table.
 Press and hold the miter detent button.
 Rotate the miter table until the pointer is at the 15° position
on the miter scale.
 Using a 4 mm hex key, loosen the 6 screws that hold the
miter scale/detent plate in place.
 Rotate the miter table until the blade is parallel with the
framing square.
 Push the miter lock lever down to lock the miter table.
SLIDING
MITER FENCE
FENCE
MITER
TABLE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
SLIDING
MITER FENCE
FENCE
ROTATING
EXTENSION
MITER
TABLE
TABLE
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
BLADE
FRAMING
SQUARE
Fig. 20
BLADE
ROTATING
EXTENSION
TABLE
FRAMING
SQUARE
Fig. 21
20 - English
 Press and hold the miter detent button. Release to engage
the detent function.
 Rotate the miter scale to the 0° position on the miter scale
or until the detent engages in the detent plate.
 Tighten the 5 visible screws that secure the miter scale/
detent plate.
 Lift the miter lock lever to unlock the miter table.
 Press the miter detent button, then rotate the miter table
to the 15° position on the miter scale.
 Tighten the remaining screw to secure the miter scale/
detent plate. Check blade squareness to fence and re-
adjust if necessary.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 23 - 24.
MITER SCALE/DETENT PLATE
SCREWS
INDICATOR
SCREW
MITER
SCALE
SCREWS
Fig. 22
SCALE
INDICATOR
Fig. 23