RIDGID R42223 Manual Del Operador página 22

ASSEMBLY
 The edge of the square and the saw blade should be
parallel as shown in figure 25.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 26 and 27, adjustments
are needed.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the bevel at any angle that allows access to the 4
screws on the back of the bevel lock bracket.
 Tighten the bevel lock knob.
 Using a 4 mm hex wrench, loosen the 4 screws that hold
the bevel detent plate in place. Do not remove the screws.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the saw at the 0º bevel angle, engage the bevel detent
lever and ensure the saw engages the detent.
 Check the 0° angle using a combination square.
 If adjustment is needed, use a 4 mm hex key to turn the
micro adjust screw on the front of the bevel lock bracket
to bring saw blade into alignment with the square.
 Tighten the bevel lock knob.
 Tighten the 2 outermost screws that retain the bevel
detent plate.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the bevel at 45°. Tighten the bevel lock knob.
 Tighten the remaining 2 screws that retain the bevel
detent plate.
 Recheck blade-to-table alignment.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 23 - 24.
MICRO ADJUST
SCREW
BEVEL LOCK
DUST COVER
REAR OF BEVEL LOCK BRACKET
SCREWS
22 - English
BEVEL DETENT
LEVER
BEVEL LOCK
KNOB
Fig. 28
SCREWS
BEVEL DETENT
PLATE
Fig. 29