Descargar Imprimir esta página

Husqvarna LF 60i LAT Manual De Usuario página 11

Ocultar thumbs Ver también para LF 60i LAT:

Publicidad

Pull out the plug to the battery charger if there is
smoke or fire.
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
Only use the battery charger where the temperature
is between 5 °C/41 °F and 40 °C/104 °F. Use the
charger in an environment which has a good airflow,
dry and without dust.
Do not put objects into the air slots of the battery
charger.
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
Do not charge non-rechargeable batteries in the
battery charger or use them in the machine.
Use an approved power outlet that are not damaged.
Do not charge if there is a risk of thunderstorm.
Only charge when the battery charger is on a level
surface.
Keep the battery charger away from children.
When the battery is charged, disconnect the battery
charger from the power outlet.
Safety instructions for operation on slopes
WARNING:
instructions that follow before you use the
product.
Do not operate the product on a slope that is more
than 20°. Loose ground, vibrations and the operation
speed can cause the product to fall on a slope that is
less than 20°.
Make sure that the work area is safe. Wet and loose
soil decreases safe operation of the product. Be very
careful on slopes and rough surfaces.
Make sure that all persons in the work area are
above the product on the slope.
Operate the product up and down the slope, not from
side to side.
Do not park the product on a slope. If you must park
the product on a slope, make sure that the product
cannot fall. There is a risk of injury and damage.
Safety instructions for operation near edges
WARNING:
instructions that follow before you use the
product.
There is a risk that the product falls when you
operate it near an edge. Always keep a minimum
of ⅔ of the product on a surface that is sufficiently
stable to hold the product weight.
If the product falls, stop the motor before you lift the
product back to a surface that is sufficiently stable.
To stop the product on page 13 .
Refer to
1948 - 003 - 13.02.2024
Read the warning
Read the warning
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
Clean the product to remove dangerous material
before you do the maintenance.
Remove the batteries from the product before you do
the maintenance.
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
Replace damaged, worn or broken parts.
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
Let an approved service agent do servicing on the
product regularly.
®
Bluetooth
CAUTION:
made to this equipment not expressly
approved by Husqvarna may void the FCC
authorization to operate this equipment.
Notice: This device complies with Part 15 of FCC
Rules and with Industry Canada licence-exempt RSS
standard. Operation is subject to the following two
conditions:
This device may not cause harmful interference
This device must accept any interference received,
including interference that cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
l'appareil ne doit pas produire de brouillage, et
l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Read the warning
Changes or modifications
11

Publicidad

loading