Husqvarna LF 60i LAT Manual De Usuario página 16

CAUTION:
water does not go into the battery
compartments.
4. Dry the product with a cloth to remove all water.
5. Clean the air intake with a soft, non-metallic brush.
6. Clean the terminals on the batteries (A) and in the
battery compartments (B) with a soft, non-metallic
brush (C).
A A
B
To clean the battery and the battery
charger
WARNING:
the battery charger with water.
16
Make sure that
C
B
Do not clean the battery or
WARNING:
substances to clean the battery.
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
Note:
The battery charger must be connected to the
voltage and frequency specified on the rating plate.
The battery does not charge if the battery temperature is
above 50 °C/122 °F. The battery charger decreases the
temperature of the battery before it starts to charge.
1. Connect one end of the power cord for the battery
charger into the socket of the battery charger.
2. Connect the other end of the power cord for the
battery charger in an grounded mains socket. The
LED on the battery charger flashes green one time.
3. Put the battery in the battery charger. The green
light on the charger comes on when the battery is
correctly connected to the battery charger.
4. When all LEDs on the battery have come on the
battery is fully charged. Charge the battery for
maximum 24 hours.
5. To disconnect the battery charger from the mains
socket, pull the plug, not the power cord.
6. Remove the battery from the battery charger.
Do not use any chemical
1948 - 003 - 13.02.2024