Publicidad
Idiomas disponibles
Idiomas disponibles
Safety, Installation and Operations Manual – Translation of original instructions
3. TRANSPORT AND STORAGE
3.1 Receiving the product
The pump is delivered suitably packaged. Make a visual inspection of the packaging for damage.
After opening, carefully remove the packaging and check the integrity of the parts.
Record any significant damage to the product in the transport documents.If articles are missing, contact Zenit (or its dealer) or the forwarders.
caution
Check that the data on the nameplate are the same as those of the product required.
caution
Keep the packaging materials for future use. If damaged, dispose of it as required by law.
Take special care not to injure yourself with sharp tools and not to damage to the product, especially the electrical wiring.
3.2 Storage
During storage, the electric pump must be kept in a suitable place, out of the reach of children or those with diminished responsibility, suitably
secured against falling and protected from damp, vibrations, dust and extreme temperatures (below -20°C/-4°F and above +60°C/140°F).
Models with cooling jacket use a 30% water-glycol mixture as coolant; this mixture retains its properties intact down to a temperature of -13°C
(9°F). At lower temperatures, the mixture becomes more viscose but it does not solidify completely, and it can therefore be used without damaging
EN
the pump.
However, the condition of the coolant mixture and the mechanical seal sump oil should be checked before using the product if it has been exposed
to low temperatures.
caution
If the pump should freeze, do not use flames to remove the ice; immerse it in the liquid in which it is to be installed until it
thaws out.
caution
Turn the impeller by hand occasionally (at least every 2 months) through the outlet or intake, to prevent the mechanical
seals from sticking together.
The impeller can have sharp edges – wear protective gloves.
38
better together
Publicidad
